Control Operation; First Use; Ice - U-Line U-CLR1215S-40B Quick Start Manual

QUICK START GUIDE

Control Operation

CONTROL FUNCTION GUIDE
FUNCTION
ON/OFF
Adjust ice thickness
View temperature in unit
Toggle between F/C
Sabbath Mode
Silent Mode (ice
production suspended for
3 hours)
Clean Mode

First Use

All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends discarding the ice produced
during the first two to three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
When plugged in, the unit will begin operating under the
factory default settings. If the unit was turned off during
installation, simply press
switch on. To turn the unit off, press
5 seconds and release.
Up Down
COMMAND
Press and release
See "Ice" section
Press together and release
and
Hold and for five seconds
See "Sabbath Mode" section
Hold and
Hold for five seconds
and the unit will immediately
and hold for
Light Power Clean LED
DISPLAY/OPTIONS
Unit will immediately turn ON or OFF.
The display will flash and then toggle from set point
to temperature in unit.
The display will beep and display unit temperature.
Display will show "OF

Ice

ICE CUBE THICKNESS ADJUSTMENT
NOTICE
Ice thickness adjustment should only be made
one increment at a time. Allow ice maker
production to stabilize for 24 hours before
rechecking ice thickness.
Ice is produced in layers resulting in a clear cube. Ice in
bin may develop surface frost which disappears when cube
is placed in liquid.
Ice cubes in any given batch will vary, so it is necessary
to choose cubes from the sample area for comparison
when making adjustments.
11
u-line.com
".
F