Table of Contents
Advertisement
SY-D6IBA2 Quick Start Guide
Install the Motherboard
Follow the steps below in order to perform the installation of your new SY-D6IBA Motherboard.
Step 1. Install the CPU
Record the working frequency of your CPU that should be clearly marked on the CPU cover.
:
FSB 66MHz
266MHz (66 x 4.0)
300MHz (66 x 4.5)
FSB 100MHz
350MHz (100 x 3. 5)
400MHz (100 x 4.0)
Notice 1: When installing two processors, please make sure the front side bus and working
frequency are identical for both processors.
Notice 2: If you are using a single processor, preferably install the processor in Slot 1 #1,
leaving Slot 1 #2 empty for future expansion to dual CPU.
Retention Module
Step 2.
Push the locks on top of the CPU
inward.
Step 4.
After completely inserting the CPU, push the two locks on
top of the CPU outward. Now your CPU is ready for use.
333MHz (66 x 5.0)
366MHz (66 x 5.5)
450MHz (100 x 4.5)
550MHz (100 x 5.5)
500MHz (100 x 5.0)
600MHz (100 x 6.0)
Step 1.
Step 3.
6
400MHz (66 x 6.0)
433MHz (66 x 6.5)
Open the two sides by folding them up.
Insert the CPU into the retention
module. The CPU fits in the CPU slot in
only ONE way, do not try to force it in.
T
o remove the CPU, press
the two notches on top of
the CPU inward. Now
press the two slides on the
retention module down and
remove the CPU.
Advertisement
Table of Contents
