Pull Pin( - Stamina In Motion II Owner's Manual

ASSEMBLY INSTRUCTIONS
STEP 3:
Place the
HEX BOLTS(M12 x 70mm)(39)
with
STEP 4:
Secure the
BUTTON HEAD BOLTS(6mm x 15mm)(40)
EXTENSION WIRE(28)
STEP 5:
Go back and tighten
EXTENSION WIRE(29)

PULL PIN(9)

through the
position.
STEP 6:
Install two "AA" batteries into the
battery installation instructions. Slide the
UPPER EXTENSION WIRE(28)
Connect the
STEP 7:
Attach the
NOTE: BUMPER STANDS(22)
The
angle of the treadmill and reduce the walking resistance. See page 10 for details on adjusting the walking
resistance.
BASE FRAME(1)
between the
and
U-SHAPED HANDRAIL(5)
LOWER EXTENSION WIRE(29).
to the
HEX BOLTS(M12 x 70mm)(39)
located on the
RIGHT UPRIGHT(3)
METER(26)
BUMPER STANDS(22)
may be stored on the end of the
LEFT
and
WASHERS(M12)(48). DO NOT TIGHTEN COMPLETEL Y.
LEFT
onto the
ARC WASHERS(M6)(44).
and
LEFT UPRIGHT(2)
BASE FRAME(1)
and
METER(26),
two batteries included. See page 8 for detailed
onto the plate on the
METER(26).
to the
to the bottom of the
7
RIGHT UPRIGHTS(2, 3)
RIGHT UPRIGHTS(2, 3)
and
Connect the
STEP 2.
in Conne ct the
SENSOR WIRE(30).
to the
BASE FRAME(1)
to lock the
U-SHAPED HANDRAIL(5).
BASE FRAME(1).
BASE FRAME(1)
and secure
with
UPPER
LOWER
In sert the
in
to increase the