Using The Electronics Meter - Stamina In Motion II Owner's Manual

USING THE ELECTRONIC METER
POWER ON :
Walking Belt movement or push the button.
POWER OFF : Automatic shut off after 4 minute s of inactivity.
MODE / CLEAR BUTTON:
Press and release to select functions.
Press and hold for three seconds to reset all
functions to zero.
FUNCTIONS:
SCAN: Automatically scans TIME, SPEED, DISTANCE, and CALORIES in sequence with a change
every four seconds. Press and release the button until " " appears on the display and points
to SCAN.
TIME:
Displays the time, from 1 sec. up to 99:59 minutes.
SPEED:
Displays the current speed, from zero to 999.9 Mile/Hr.
DISTANCE:
Displays the distance, from zero to 99.99 miles.
CALORIES:
Displays the calorie consumption, from zero to 999.9 Kcal.
The calorie readout is an estimate for an average user. It should be used only a s a comparison
between workouts on this unit.
HOW TO INSTALL AND REPLACE BATTERY:
1. Open the Battery Door on the back of the meter.
2. The meter operate s with two AA batteries, two batterie s included.
Refer to the illustration to install or replace the batteries.
NOTE:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix a n alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.
8
AA Batteries