Hardware Illustrations - Stamina In Motion II Owner's Manual

HARDWARE IDENTIFICATION CHAT
This chart is provided to help identify the hardware used in the assembly process.
After unpacking the unit, open the hardware bag and make sure that you have the following items:
3/16" 1/4"
0 1/2 1
0 10 20
6
Place washers, the end of bolts or screws on the circle s to che ck for the
correct size. Use the small scale to check the sizes of bolts and screws.
NOTICE: The length of all kinds of screws a nd bolts are not included
themselves head, except the flat head screws and bolts.
NOTE: 1. Some of the hardware items listed may be attached to other parts.
2. Bolt length is measured from the bottom of the bolt head to the end of the bolt.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
38
39
40
44
47
48
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Bolt, Hex Head (M10 x 1.5 x 20mm)
Bolt, Hex Head (M12 x 1.75 x 70mm)
Bolt, Button Head (M6 x 1 x 15mm)
Arc Washer (M6)
Washer (M10)
Washer (M12)
5
INCHES
1/2 5 1/2
length
6
in.
mm.
length
Qty
4
2
2
2
4
2