Assembly Instructions; Ball Knob( - Stamina In Motion II Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cle ared area and position them on the floor in front of you. Re move all
packing materials from your area and place them back into the box. Do not dispose of the pa cking materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part ple ase
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at:
parts@staminaproducts.com
Sensor Wire
STEP 1
NOTE: LEFT UPRIGHT(2)
The is the one with the Sensor Wire.
LEFT RIGHT UPRIGHTS(2, 3) UPRIGHT SUPPORT(4) HEX BOLTS
Attach the and to the with
(M10 x 20mm)(38) WASHERS(M10)(47).
and
STEP 2
SPRING(7) SPRING PIN(6). SPRING PIN(6)
Slide the onto the Insert the threaded end of the through
RIGHT UPRIGHT(3)

BALL KNOB(8)

PRING
the collar on the and screw the onto the thre ad end of the S
PIN(6). BALL KNOB(8)
Tighten the as tight as you can by hand.
6