Operating Instructions - Worx WG259E Safety And Operating Manual

OPERATING INSTRUCTIONS

WARNING! Do not use the product without
attaching the guard and front handle.
INteNDeD USe
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
1. GUARD ASSeMBly
Insert the Safety Guard (4) into the slot as illustrated in
Fig A; making sure it is securely attached.
Use two screws to fix the Safety Guard securely.
2. fRoNt HANDle ASSeMBly
The Front Handle (3) must be assembled before use:
1) Remove the bolt from the Front Handle.
2) Attach the Front Handle to the housing. Make
sure the protruding marks on the Front Handle
fit perfectly into the matching indentation on the
housing. (See Fig. B&C)
3) Insert the locking bolt into the handle and fully
tighten the bolt. (See Fig. D)
4) Check whether handle is firmly secured, if not
retighten the locking bolt.
Note: Make sure the handle is firmly secured in
place.
3. BefoRe USING yoUR coRDleSS tool
WARNING! The charger and battery pack are
specially designed to work together so do not
attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack
connections because of an electrical failure and hazard
will occur.
Your battery pack is UNCHARGED and you must charge
once before use.
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
4. cHARGING yoUR BAtteRy PAck
The Li-Ion battery is protected against deep
discharging. When the battery is empty, the machine is
switched off by means of a protective circuit:
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
Cordless Hedge Trimmer
A
B
C
D
WG259E.5 WG259E.9
WG259E
9