Fcc Notice - Standard Horizon HX300 Owner's Manual

13. FCC NOTICE

Unauthorized changes or modifications to this equipment may void
compliance with FCC Rules. Any change or modification must be
approved in writing by STANDARD HORIZON, a division of YAESU
USA.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
 Consult the dealer or an experienced marine electronics techni-
cian for help.
This device is intended for general population use to satisfy FCC RX
exposure compliance. See section "1.2 SAFETY INFORMATION" for
specific operating requirement.
This device complies with part 15 of the FCC rules. Operation is sub-
ject to the condition that this device does not cause harmful interfer-
ence.
Part 15.21: Changes or modifications to this device not expressly
approved by YAESU MUSEN could void the User's authorization to
operate this device.
HX300
NOTICE
NOTICE
CAUTION
Page 47