Operation; Priority Scan - Standard Horizon HX300 Owner's Manual

Priority Scan: Scans the Scan Memory Channel,
Memory Scan: Scans the Scan Memory and chan-
6. After completing your selection, turn the transceiver
off and on by press and holding the
P
riority

6.9.3 OPERATION

The operation of the "Priority Scan" or "Memory Scan" is determined via the
section "6.9.2 SELECTING THE SCAN TYPE"

6.9.3.1 Priority Scan

1. Press the
the squelch adjusting mode, then press the
ground noise disappears.
2. Press the
blinking "
play during scanning.
3. When the HX300 receives a transmission on a work-
ing channel, it will stop on the working channel and
"Dual Watch" (described in next chapter) to the prior-
ity channel until the incoming signal disappears, then
start scanning again.
4. When the HX300 receives a signal on the Priority
channel it will stay on this channel until the incoming
signal disappears, then start Priority scanning again.
5. To stop the scanning, press the
HX300
Preset Channel, and the Priority
Channel (Channel 16).
nels programmed into the Preset
Channel memory.
S
can
key two times until the "SQL" indicator blinks, to activate
key to start scanning, a "
" and " " icons will appears on the dis-
key.
M
eMory
/
" icon and
key.
S
can
key until the back-
Page 29