Install Or Remove An X2 Transceiver; To Remove The X2 Transceiver - HP J8726A Installation Manual

Installing the Modules
Note
Note
22

Install or Remove an X2 Transceiver

Hot swapping transceivers is supported. You can install or remove a trans-
ceiver with the switch powered on, a reset will not occur.
a. Slide the transceiver in until it stops.
b. Push firmly until the gasket seats against the bulkhead.
When switch power is on, the Link and Mode LEDs will come on for approx-
imately two seconds and then go off. This is confirmation the transceiver is
completely seated.
c. If your transceiver has a bail, move the bail up, if not your transceiver is
now completely installed.

To remove the X2 transceiver:

If your transceiver has a bail, lower the bail until it is approximately horizontal,
and then using the bail, pull the transceiver from the slot. If your transceiver
does not have a bail, pull the transceiver straight out.
Bail