Advertisement
✻
Multi-mode (E-mail notification)
86
Address(es)
0 = Disable multi-mode devices
1 = Enable multi-mode device address #6 only
2 = Enable multi-mode device address #7 only
3 = Enable multi-mode addresses #6 & #7
Field * 80, which is normally used to program X10 Powerline Carrier Devices, is now also used to program
Multi-mode (e-mail) Event Triggers. Up to eight events can be programmed; these are assigned as Device
Numbers 09-16 in *80.
Programming Default Tables
In addition to adding new defaults associated with these new features, the start/end defaults for Daylight
Savings time have been revised. The revised defaults are as follows:
Function
*29 Daylight saving time start/end month
*30 Daylight saving time start/end weekend
*55 Reporting Channels
*78 Programmable Tone Generation Time
*86 Multi-mode (E-mail notification)
✻
80 DEFAULT TABLE: APPLIES TO DEFAULT TABLE 1 and 2 (devices 01-07 and 09-15 have no default values)
Device Number
16
✻
80 DEFAULT TABLE: APPLIES TO DEFAULT TABLE 4 (devices 02-07 and 10-15 have no default values)
Device Number
09
16
For ZT42 (Low Batt) use only as a start, with a stop of ZT22 (disarm). If ZT42 is used for
both start and stop it will not trigger.
Action
Event
Zone List
2
Action
Event
Zone List
2
2
2
Enable if using AlarmNet Remote Services e-mail
notification (multi-mode) feature. The address(es) used
must also be enabled in the AlarmNet communication
device. For more information refer to the instructions
provided with the Communications Device being installed.
Table 1
Table 2
3,11
3,11
2,1
0
0,0
0
Start
Zone Type
System Operation
33
Start
Zone Type
System Operation
1
33
- 6 -
Table 3
3,11
2,1
2,1
0
0
0,0
0,0
0
0
Stop
Restore of
Zone type
Zone List
System operation
Stop
Restore of
Zone type
Zone List
System operation
2
Table 4
3,11
2,1
0
0,0
0
36
36
Advertisement
