Panasonic KX-TVS100 Quick Installation Manual page 37

Operator Transfer Sequence: This setting tells the VPS how to transfer a call to the operator.
Example: FTX [hookswitch flash—wait for dial-tone—dial (operator)
Extension Transfer Sequence: This setting tells the VPS how to transfer a call to an extension.
Example: FTX [hookswitch flash—wait for dialtone—dial extension]
Alternate Extension (Transfer Sequence): This setting tells the VPS how to transfer a call to an
extension that is entered into the "Alternate Extension Group." This is useful for extensions that
need a special transfer procedure (ie. blind transfer) such as modem extensions.
Example: FTXD [hookswitch flash—wait for dialtone—dial
extension—hang up]
Reconnect Sequence on Busy: If the extension the caller has dialed is busy, this setting tells the
VPS how to return to the caller. PBXs differ in how they handle this function. Test from an SLT to
determine the sequence.
Reconnect Sequence on No-Answer: If the extension the caller has dialed does not answer, this
setting tells the VPS how to return to the caller. PBXs differ in how they handle this function. Test
from an SLT to determine the sequence.
Reconnect Sequence on Transfer Refused: If the extension the caller has dialed has Call
Screening enabled and the subscriber chooses not to take the call, this setting tells the VPS how to
return to the caller. PBXs differ in how they handle this function. Test from an SLT to determine
the sequence.
Light On Sequence for Message Waiting Lamp: This is the dialing sequence that the VPS must
use to turn on a message lamp at an extension.
Light Off Sequence for Message Waiting Lamp: This is the dialing sequence that the VPS must
use to turn off a message lamp at an extension.
Call Waiting Sequence: This sequence is carried out by the VPS to perform call waiting when the
extension being called is busy. PBXs differ in how they handle this function. Test from an SLT to
determine the sequence.
Release Sequence for Call Waiting: This sequence is carried out by the VPS to release call
waiting. PBXs differ in how they handle this function. Test from an SLT to determine the
sequence.
SEQUENCE CODES
D Disconnect
F Hookswitch Flash
R Ring Detection
S Silence Detection
T Dialtone Detection
W Wait for 1 Second
X Dial Extension
0-9, *, # DTMF Digits
extension]
6.37