Table of Contents
Advertisement
Indoor Unit Installation
Concrete
Hole in anchor
Hole in plug
Suspension bolt(M8)-field supply
Ceiling support
10mm
Drain hose connection port
10
E-
Mark the place to insert the suspension bolt where you want to install the
1
indoor unit.
N N
o o
t t
e e
N N
o o
t t
e e
Insert bolt anchors. Use existing ceiling supports or construct a suitable
2
support as shown in figure.
Insert
Install the suspension bolts depending on the ceiling type.
3
IMPORTANT
Screw eight nuts to the suspension bolts making space for hanging
4
the indoor unit.
IMPORTANT
Hang the indoor unit to the suspension bolts between two nuts.
5
N N
o o
t t
e e
N N
o o
t t
e e
Screw the nuts to suspend the unit.
6
Adjust level of the unit by using measurement plate for all 4 sides.
7
N N
o o
t t
e e
N N
o o
t t
e e
Refer to page 9 for the dimension.
Ensure that the ceiling is strong enough to support
the weight of the indoor unit.
Before hanging the unit, test the strength of each
attached suspension bolt.
You must install the suspension bolts more than 4
when installing the indoor unit.
Tubing must be laid and connected inside the ceiling when
suspending the unit. If the ceiling is already constructed,
lay the tubing into position for connection to the unit before
placing the unit inside the ceiling.
For proper drainage of condensate, give a 10mm slant to the
left or right side of the unit which will be connected with the drain
hose, as shown in the figure. Make a tilt when you wish to install
the drain pump, too.
Advertisement
Table of Contents
