Assigning Address to Indoor Unit
30
E-
Before installing the indoor unit, assign an address to the indoor unit
1
according to the air conditioning system plan.
The address of the indoor unit is assigned by adjusting MAIN(SW02) and
2
RMC(SW04) rotary switches.
SW02
K1 K2 K3 K4
K5 K6 K7 K8
SW05
SW06
It is required to set the RMC address if you install the wired remote controller
3
and/or the centralized controller.
If you install optional accessories such as the wired remote controller, centralized
4
controller, etc. see an appropriate installation manual.
If an optional accessory is not installed, you do not have to set the RMC
5
address. However, adjust K1 and K2 switches of the SW05 DIP switch to "ON"
position in this case.
SW02
SW04
SW05
SW06
SW07
SW04
K9 K10 K11 K12
SW07