Maintenance - Worx WG152 Manual

To REPlaCE CuT liNE.
For your convenience it is recommended you
buy spool and line preinstalled.
To FiT SPool aNd liNE aSSEMbly:
Remove old spool.
Place new spool into cap with cut out areas
of the spool in line with eyelets.
Release line from cleat and feed line through
eyelet .
Refit the cap.
To FiT NyloN liNE oNly:
waRNiNG! Take approximately 16ft
(5m) of line. Insert 5/8"(15mm )of line
into the spool holes and wind line in the
direction of the arrows on the top of the spool.
Your Trimmer is designed to use only line with
a maximum diameter of 0.065"
iMPoRTaNT: Leave approximately
4"(100mm) of line unwound and place into
cleat.
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit spool as described in "To fit spool
and line assembly".
12 12

MAINTENANCE

After use, disconnect the battery from the
tool and check for damage. Your grass
trimmer requires no additional lubrication or
maintenance. There are no user serviceable
parts in your grass trimmer.
Never use water or chemical cleaners to clean
your grass trimmer. Wipe clean with a dry
cloth. Always store your grass trimmer in a
dry place out of the reach of children. Keep the
motor ventilation slots clean. Keep all working
controls free of dust. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your grass trimmer.
2-in-1 Cordless Grass Trimmer/Edger
EN