Sym Wolf SB 250 Ni Service Manual page 13

1. General Information
●
Do not let the wire harness be twisted when
installation.
●
Wire harnesses routed along the handlebar
should not be pulled too tight or have
excessive slack, use rubber covering against
adjacent or surrounding parts in all steering
perimeters.
●
Before operating a test instrument, the
operator should read the operation manual of
the instrument, and then conducts test in
accordance with the instruction.
Do you know how to set the
instrument to its measurement
position and the insert locations
of its two probes?
1-8
●
Use sand paper to clean connector
pins/terminals if rust is found. And then
continue the connection operation.
Clean rust