Sym Wolf SB 250 Ni Service Manual page 12

● Do not let the wire harness contact with
rotating, moving or vibrating components
when routing the harness.
●
Keep wire harnesses far away from the hot
parts.
●
Avoid wire harnesses from sharp edges or
corners, and also avoid the jutted-out ends of
bolts and screws.
●
Route harnesses so that they neither pull too
tight nor have excessive slack.
Never too tight
Never Touch
1. General Information
●
Protect wires or wire harnesses with electrical
tape or tube if they contact a sharp edge or
corner. Thoroughly clean the surface where
tape is to be applied.
●
Secure the rubber boot firmly as applying it on
wire harness.
●
Never use wires or harnesses which insulation
has broken. Wrap electrical tape around the
damaged parts or replace them.
●
Never clamp or squeeze the wire harness
when installing other components.
Never clamp or squeeze
the wire harness
1-7