Xerox DocuPrint N2025 Service Manual page 5

Organization
This manual is divided into seven sections. The title and description of
each section of the manual is as follows:
Section 1 - Service Call Procedures
This section is used to identify a suspected problem. It contains
Machine Orientation, Call Flow, Initial Actions, Corrective Actions, and
Final Actions. This part of the service manual should always be used to
start the service call.
Section 2 - Repair Analysis Procedures
This section is used to isolate and identify problems to a faulty
component or subassembly. It contains the introduction, display
message table, error code tables and the Repair Analysis Procedures
(RAPs).
Section 3 - Image Quality
This section contains image quality repair procedures to assist in
correcting image quality defects. These procedures provide defect
samples and definitions to help identify the type of defect that exists,
the test pattern to use, and actions required to correct the defects.
Section 4 - Repair / Adjustment
This section contains the instructions for removal, replacement, and
adjustment of the spared parts within the machine.
Section 5 - Parts Lists
This section contains illustrations of disassembled subsystems and a
listing of the spared parts.
Part names are listed in this section of the manual even if the part itself
is not spared. All the parts that are spared will have the part number
listed. Parts that are not spared will not have a number listed.
Section 6 - General Procedures
This section includes the Operations Menu Map and the Service Mode
Menu Map. It includes all unique service operations, supplemental tools
and supplies.
Initial Issue
DocuPrint N2025/N2825
Section 7 - Wiring Data
This section contains sensor, connector, and PWB location drawings;
power distribution diagrams, interconect diagrams, interconnect
diagrams and pin assignment information. This information is not
specific to individual procedures but is provided for general reference.
02/2000
v
Organization