Table of Contents
Advertisement
Operating Instructions
Charging the battery pack
1. For maximum running time, always charge the
battery pack before use. There is a power level
indicator located at the connector side of the
battery pack which indicates the amount of power
left in the battery pack by pressing on to the
"Push" button. The battery pack may require
charging if stored for four weeks or longer.
If the battery pack is not used for a long time,
once a year fully charge it and then fully use
it up on your vacuum before storing in a dry,
cool place.
Battery
2. The battery pack can be charged at any time,
and does not need to be entirely discharged.
3. A battery pack lasts for approximately 500
to 600 cycles of charging.
4. If charging is required, use original charger
(Part No. KC470) when charging this battery pack.
5. You do not need to remove battery pack from
machine to charge (Please Note: Do Not
operate machine whilst charging battery pack).
6. Ensure the machine and charger are on a level
surface with adequate ventilation.
7. Ensure machine and charger are both in the
OFF ( o ) position.
8. Ensure correct input voltage is selected in the
charger.
9. Plug in charger power cord to mains power
supply (ensure mains power supply is switched
OFF when plugging in).
4
10. Plug in charger socket head in to battery pack.
Ensure correct direction so as not to damage
socket pins.
Charger socket head
Battery Pack
11. Switch ON mains power supply.
12. Switch ON the charger.
13. The left Light Emitting Diode (LED) indicator on
the charger will show a Red light (i.e power ON).
Charger
Red Light = ON
14. The right Light Emitting Diode (LED) indicator
on the charger will show a Yellow light
(i.e CHARGING).
Charger
Yellow Light = Charging
15. LED indication:
LED (Power) RED LIGHT ON:
Power On
LED (Charge) YELLOW LIGHT ON: Charging
GREEN LIGHT ON: Fully Charged
GREEN LIGHT ON: Disconnect
PLEASE NOTE:
The battery will be fully charged in 2 hours.
16. Charging is complete when right LED light is Green.
Charger
Green Light = Ready to use
17. Switch off mains power supply and charger, and
unplug charger socket head from battery pack.
18. The battery pack is ready to use.
19. PLEASE NOTE: Battery pack performance
decreases in low-temperature surroundings,
reducing the time the battery pack can be used.
20. PLEASE NOTE: The battery pack does
become slightly heated while in use.
Operating Instructions
Installing battery pack to vacuum unit
1. Ensure vacuum unit power switch is in the
OFF position.
2. Insert battery pack into battery pouch that comes
with your machine. Please check battery pack
has been inserted so that battery level is showing.
Battery Level
3. Ensure it is securely bound in position with
velcro strap.
4. Insert battery connector to vacuum unit socket.
Turn connector clockwise to lock.
www.pacvac.com
Support: 08 9479 1444
5
Advertisement
Table of Contents
