Replacing A Designer Color Filter - PRG Best Boy 4000 Service Manual

Replacing a Designer Color Filter

Parts:
Designer Color Filter(s), as required. (Refer to
Tools & Supplies:
#2 Phillips screwdriver
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
To replace a designer color filter:
Step 1. Remove power from luminaire.
Step 2. Remove R2/Designer Head Cover. (Refer to
CAUTION: Do not touch color filters with bare fingers. Wear cotton gloves or finger cots when handling.
Step 3. Rotate wheel until desired designer color filter is accessible (Figure 3-15).
Step 4. Using fingers, grasp frame of color filter and pull straight out of wheel hub.
®
40 BEST BOY 4000 SPOT LUMINAIRE FIELD SERVICE MANUAL
"Designer Color Wheel Standard Configuration"
"Removing Head Covers"
Designer Color Filter
Carrier
Wheel Hub
Figure 3-15: Removing a Designer Color Filter
on page 8.)
on page 24.)