PRG Best Boy 4000 Service Manual page 25

Mechanism Errors
Errors will be shown after the mechanism code, for example: PAN:Comm Error.
Error Code
Cal Error
Cal Timeout
Comm Error
Get Position Error
Init Error
Motion Error
No Sensor
No Stop
Sensor Stuck
Spin Error
Stop Spin Error
Explanation
Error resetting position values in motion
processor at beginning of calibration
An action during calibration took longer
than expected
Error communicating with motion
processor
Error when retrieving current position
from motion processor
Error during initialization of motion
processor
Mechanism's actual position is too far
from its commanded position
During calibration, no sensor was found
in the range of travel
Mechanism which calibrates to a
physical stop did not find that stop
During calibration, could not find either
edge of the sensor or the sensor did not
turn off as expected
Error while sending spin command to
motion processor
Error while sending stop spin command
to motion processor
Solution
Check CAN cables/connections, motor
control board
Check CAN cables/connections, motor
control board
Check CAN cables/connections, motor
control board
Check CAN cables/connections, motor
control board
Check CAN cables/connections, motor
control board
Check mechanism motion
Check for mechanism motion, sensor
operation
Check mechanism
Check for mechanism motion, sensor
operation
Check CAN cables/connections, motor
control board
Check CAN cables/connections, motor
control board
®
BEST BOY 4000 SPOT LUMINAIRE FIELD SERVICE MANUAL 17