Troubleshooting - BLADEZ Conquest Owner's Manual

PROBLEM
1. The console does
not switch on.
2. The treadmill does not
work.
3. Walking motion is jerky
on the treadmill.
4. The treadmill belt skews
off center.
5. Error Signal Display：
Error 1：The treadmill can't
read the speed value.
Error 6：Incline motor
doesn't run.
Error 7：Incline is too high
or too low (exceed the
range).

TROUBLESHOOTING

CHECKS
1a) Make sure that the
machine is plugged in and the
ON/OFF switch is in
position I.
1b) Verify that the console
electric supply cable is
connected.
Check if the electrical outlets
fuse or circuit breaker has
shut off.
3a) Check if the belt is
lubricated.
3b) Check the tension on the
running belt.
3c) Check the tension on the
AC motor drive belt drive belt.
4a) Check if the machine is
level on the floor.
4b) Check if the machine
wobbles.
4c) Check alignment of the
front and rear rollers.
5a) Check if the speed sensor
is plugged in
5b) Check the speed sensor
functionality
5c) Calibrate the incline motor
14
SOLUTIONS
1a) Plug the machine into the
power supply. Set the switch
to position I.
1b) Connect the console
electric supply cable.
Replace fuse or circuit breaker.
Contact a qualified electrician
if required. Plug the treadmill
into a dedicated 110-120V, 15
or 20 Amp outlet to ensure the
treadmill receives the
appropriate amount of current
to function correctly. The
outlet must not supply
electricity to any other device.
3a) Lubricate the sliding belt.
3b) Adjust the belt tension.
3c) Adjust the drive belt
tension.
4a, 4b) Level the machine.
4c) Align the front and rear
rollers.
Contact BH Fitness Customer
Service. See Warranty pages
at the end of this Manual.
Conquest