Dmx-Protocol; Protocôle Dmx - EuroLite TMH-155 Moving-Head User Manual

Controlling:
After having addressed all TMH-155, you may now start operating these via your lighting controller.
Note:
After switching on, the TMH-155 will automatically detect whether DMX 512 data is received or not. If the
data is received, the the display will show "A001" with actually set address and the DMX-LED is lit. If there is
no data received at the DMX-input, the DMX-LED is off.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TMH-155.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.

DMX-PROTOCOL

Control channel 1 - Horizontal movement (Pan) (within 360°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
Control channel 2 - Vertical movement (Tilt) (within 250°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
Control channel 3 - Colour-wheel
DMX-value Feature
0-15 Open / white
16-31 Pink
32-47 Blue
48-63 Orange
64-79 Green
80-95 Violet
96-111 Yellow
112-127 Red
128-255 Rainbow effect with increasing speed
Control channel 4 - Rotating gobo index, gobo rotation
DMX-value Feature
0-127 Gobo indexing
128-189 Forwards gobo rotation with decreasing speed
190-193 No rotation
194-255 Backwards gobo rotation with increasing speed
Control channel 5 - Rotating gobo-wheel
DMX-value Feature
0-31 Open
32-63 Gobo 1
64-95 Gobo 2
96-127 Gobo 3
128-159 Gobo 4
160-191 Gobo 5
192-223 Gobo 6
224-255 Gobo 7
28/58 51786410X84NXS_V_1_2.DOC