Bosch Power Xpress Installation And Operating Instructions Manual page 19

ss01456
14. Using a 1 1/16-in. (28-mm) hole saw, with the pilot
hole as a guide, drill out the knockout.
CAUTION: Use a mid-range speed setting
and drill carefully to avoid punching
through housing and damaging internal
components.
ss01481
15. Remove debris from wiring chamber.
16. Install the 3/4-in. (19-mm) cable gland adaptor with
nut and O-ring into drilled 1 1/16-in. (28-mm) hole
in the Charge Station. Securely tighten.
17. Assemble the 3/4-in. (19-mm) cable gland cap to
the molded plug/cable assembly.
ss01429
18. Remove the strain-relief assembly from the wiring
chamber.
Bosch Automotive Service Solutions LLC
Installation and Operating Instructions | Power Xpress Charge Station | 17 | en
ss01432
19. Remove threaded ground lug.
ss01434
20. Feed molded plug/cable/cable gland assembly
through the 1 1/16-in. (28-mm) hole in the housing
and orient the conductor wire to the terminal block.
Remove strip/retain insulation ends.
L2/N
21. Feed the L1 (black) [Europe H (brown)] wire into
the L1 [Europe H] terminal slot in the wiring cham-
ber.
22. Feed the L2 (red) wire into the L2 terminal slot in
the wiring chamber.
23. Attach safety ground wire through the slot on the
ground terminal. Hand-tighten grounding lug.
Note:
See inside of wiring chamber cover for wiring schematic.
24. Tighten terminal screws to 1.2 Nm (10.62 in-lb).
L2/N
L2/N
L1
EL -50600-7-2 | REV. B | 20.10.2013