Bosch Power Xpress Installation And Operating Instructions Manual page 12

en | 1 0 | Installation and Operating Instructions | Power Xpress Charge Station
ss01415
7. Remove the template from the wall. Using a ham-
mer, install a plastic drywall anchor in each of the
six (6) „B" holes.
Note:
Charge Station support-strength requirement is based
on a minimum 3/8-in. (1-cm) drywall thickness
ss01417
8. Align mounting plate with installed plastic anchors
and secure with six (6) #8 pan-head screws.
ss01418
9. Feed sufficient wire from the service panel through
the wire-access hole to make connections to the
Charge Station terminal block.
EL -50600-7-2 | REV. B | 20.10.2013
Note:
To avoid damage to the front of the Charge Station,
place it on a soft or cardboard surface.
ss01419
10. Drill a pilot hole in the center of the rear knockout
on the Charge Station unit.
ss01420
11. Using a 1 1/16-in. (28-mm) hole saw, with the pilot
hole as a guide, drill out the rear knockout.
CAUTION: Use a mid-range speed setting
and drill carefully to avoid punching through
housing and damaging internal components.
12. Remove debris from wiring chamber.
ss01421
13. For indoor installation, assemble the plastic hole-
bushing into the knockout and firmly snap into place.
Bosch Automotive Service Solutions LLC