Enabling Ais; Displaying Ais Vectors - Raymarine a series Installation And Operation Instructions Manual

13.4 Enabling AIS

Enabling AIS in the Chart application
To enable AIS overlay in the Chart application the chart view
must be set to 2D Menu > Presentation > Chart View.
From the Chart application:
1. Select Menu.
2. Select Presentation.
3. Select Overlays.
4. Select AIS: so that On is highlighted.
Selecting AIS will switch AIS between On and Off.
Enabling AIS in the radar application
From the radar application:
1. Select Menu.
2. Select Track Targets.
3. Select AIS Targets so that On is highlighted.
Selecting AIS Targets will switch AIS between On and Off.
132

13.5 Displaying AIS vectors

You must have the correct data available before AIS vectors
can be displayed.
A target is defined as active when it has the following data
displayed graphically:
• A COG/SOG vector indicating the predicted distance that a
target will travel within a given period of time.
• A heading and direction of turn indicator.
Enabling and disabling AIS vectors
From the chart or radar application:
1. Select an AIS target.
The AIS target context menu is displayed.
2. Select AIS Vector.
Selecting AIS Vector will switch between On and Off.
Note: The same target vector and safe zone settings apply
to both radar MARPA and AIS targets.
New a Series / New c Series / New e Series