Cleaning The Sensor Window; Replacing The Remote Control Batteries - Hoover RoboCom 2 Instruction Manual

Cleaning the Sensor Window

container is emptied. Frequent cleaning is recommended to ensure optimum performance of your Robo.
Use a dry soft cloth or cotton swab to wipe the sensor window.
Cleaning the Floor Polisher Pad*
1.
2.
3. Press the Floor Polisher Pad Holder* release button and unclip from the dust container.
4. Tear the Floor Polisher Pad* from the Floor Polisher Pad Holder* and wash using hand warm water.
Remove excess water and leave to dry before re-using.
5. Re-assemble when fully dry.
Replacing the batteries
and will invalidate your guarantee.
batteries and store in a dry location.
1.
then remove the battery cover.
2. Remove the old battery pack and replace with the new battery pack ensuring the polarity is correct.
Replace the cover.
3.
Replacing the Remote Control** batteries
1. Remove the battery cover.
2. Remove the old batteries and replace with the new batteries ensuring the polarity is correct. Replace
the cover.
Replacing the Virtual Barrier* batteries
1. Turn the Virtual Barrier* over and rotate the retaining clip. Remove the battery cover.
2. Remove the old batteries and replace with the new batteries ensuring the polarity is correct. Replace
the cover.
* Certain Models Only
** May vary according to model
RoboCom2Manual2011__GB.indd 13
GB
14/07/2011 13.40.17