Self-Cleaning Function; Emptying Dirty Water Tank - Hoover STREAMLINE User Manual

2
Press the power button (power symbol) to turn
the unit on.
3
Engage with + or – button to change modes
depending on your cleaning needs.
4
Press the (+) sign located under the power
button. When cleaning tough stains and/or big
messes, use boost mode for more power and
more water. To turn off boost mode, press the
(+) sign again. When in standard cleaning mode
press the minus sign to enter dry only mode.
SELF-CLEANING
FUNCTION
CAUTION:
Water will drip from the
brush roll and underside of the product after
use and may puddle. To avoid damage to wood
and laminate flooring and to avoid potential slip
hazard after use (A) do not need the product on
wood and laminate surfaces and (B) placed unit
on provided storage tray to contain drips.
IMPORTANT: Do not use solvent-based cleaning
concentrates in your cleaner. Do not use any
type of wax in your cleaner. Dry hands and plug
cleaner into a properly grounded outlet.
1
Ensure solution tank is filled to the "Self-Clean"
line. If your solution is empty or does not reach
that line, fill the tank to the fill line with warm
water.
2
Place the unit upright in the self-clean tray.
3
Self-clean will run for 90 seconds and
automatically switch off when complete.

EMPTYING DIRTY WATER TANK

1
Once self-cleaning is done. Remove dirty water
tank. To remove the tank, press down on the
release latch on the front of the tank and pull the
tank away from the unit.
2
Remove filter from top of dirty water tank, rinse
with water and place in the designated area on
self-clean tray
PINCH SIDES AND PULL
3
Empty the tank and rinse.
4
Leave tank and lid out to dry before placing back
in machine
TIP: Use for picking up small liquid spills (one
gallon or less, never to exceed 1/8" in depth).
When vacuuming liquid, make sure the product
does not get submerged or doused in liquid,
which could cause shock, product failure, or
personal injury. Ensure filter dries for 24 hrs
before reinserting into machine for next use.
3
CLEANING THE BRUSH
ROLL & FOOT
WARNING:
To reduce the risk of injury
from moving parts remove the battery before
servicing. Do not use cleaner without nozzle
in place.
LUBRICATION: The motor and brush roll are
equipped with bearings which contain sufficient
lubrication for their lifetime. The addition of
lubricant could cause damage. Do not add
lubricant to motor or brush roll.
PINCHING CLIPS
1
Press the clips on the brush roll cover and lift
cover to remove.
2
Pull the tab up on the outer side of the brush roll
and pull up to remove.
3
Rinse the brush roll and brush roll cover in water.