Hoover RoboCom 2 Instruction Manual page 13

Hide thumbs Also See for RoboCom 2:
Table of Contents

Advertisement

GB
RoboCom2Manual2011__GB.indd 12
Cleaning the Edge Cleaning Brush
The Edge Cleaning Brush can be easily worn from heavy use so you should check it regularly to monitor its
condition.
1.
2.
Remove the retaining screw with a screwdriver.
3.
Use a pair of scissors to remove any trapped hair or debris.
Correcting Edge Cleaning Brush Deformation
The Edge Cleaning Brush can sometimes be deformed during transportation or when the product is used
under particular conditions. If this happens it is possible to return to the original shape by putting the bristles
in hot water.
GOOD
1.
2.
Remove the retaining screw with a screwdriver. Remove the Edge Cleaning Brush.
3.
Gently lower the bristles in hot water.
4.
Hold each set of bristles until they have recovered and straightened. Then remove and leave to dry.
5.
Once completely dry reassemble and screw in place.
Replacing the Edge Cleaning Brush
If the Edge Cleaning Brush is damaged it will need to be replaced. Replacement Edge Cleaning Brushes can be
obtained from your Hoover retailer.
1.
2.
Remove the retaining screw with a screwdriver.
3.
Remove the old Edge Cleaning Brush and push the new one in place.
4.
Replace and tighten the screw.
Cleaning the Front Wheel
1.
2.
Remove any dirt or hair trapped in the wheel.
3.
Clean the wheel with a dry cloth.
4.
Check that the wheel can rotate freely.
Cleaning the Floor Sensors
container is emptied. Frequent cleaning is recommended to ensure optimum cleaning performance and safe
1.
2.
3.
Use a dry soft cloth or cotton swab to wipe the sensors.
* Certain Models Only
** May vary according to model
RECOVERABLE
REQUIRES REPLACEMENT
14/07/2011 13.40.14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents