Emptying The Dust Container - Hoover RoboCom 2 Instruction Manual

GB
RoboCom2Manual2011__GB.indd 10
1.
2. Use a damp cloth with a little soap to clean all surfaces. DO NOT allow water into any part of the product
whilst cleaning.
3. Dry with a soft Cloth.

Emptying the dust container

Empty the dust container every cleaning cycle or when the dust container is full.
1.
2.
3. Hold the dust container over a bin to empty.
4. Use the Multi-purpose Cleaning Brush when necessary to remove any excess dust from the internal
surface of the dust container.
5.
invalidate your guarantee.
1.
2.
3.
4.
5.
cloth and leave to dry.
6.
cleaners performance.
CLEAN FILTER REGULARLY
Cleaning the Dust Sensors
The dust sensors are located in the dust container of Robo.com². Clean the sensor window each time the dust
container is emptied. Frequent cleaning is recommended to ensure optimum performance of your Robo.com².
Use a dry soft cloth or cotton swab to wipe the sensor window.
Cleaning the Motor Assembly
Under normal conditions of use, the motor assembly will not require any maintenance unless the pre motor
1.
2.
3. Press the motor release button, the motor will pop out.
4. Turn the motor over and unclip the exhaust cover.
5. Clean using the Multi-purpose Cleaning Brush provided.
IMPORTANT: Never use water to clean the motor.
* Certain Models Only
** May vary according to model
PULL TO ACCESS THE FILTER
14/07/2011 13.40.10