FLIR PT series Installation Manual page 13

1 PT-Series Camera Installation
The figure below shows the locations of dip switches SW102 and SW103.
If the Software Override DIP switch is set to the software position (as it is by default), all of the other
DIP switches will be ignored, and configuration changes must be made through software. If the switch
is set to the hardware position, all configuration settings related to serial communications are made
with the DIP switches, and changes that are made via software (with a web browser) will be ignored.
Serial Address: Use the block of switches on the left (SW102) to set the serial address of the
camera. The available range of values is from decimal 1 to 255. The dip switches are interpreted as a
binary number, with switch 1 representing the least significant bit (the switches are in the reverse
order of the bits). For convenience, a table of serial addresses and their binary equivalents is included
at the end of the manual. See "Serial Address: Decimal To Binary Conversion" on page 3-1.
ID
1
2
3
...
255
427-0032-00-12, Version 170
SW102
Figure 1-4: PT-Series Camera Configuration
Table 1-1: Dip Switch Address/ID Settings—SW101
Sw 1
Sw 2 Sw 3
LSB
On Off Off
Off On Off
On On Off
... ... ...
On On On
Sw 4 Sw 5
Off Off
Off Off
Off Off
... ...
On On
Mar 2014
SW103 Switch
Position
Off
On
Sw 8
Sw 6 Sw 7
MSB
Off Off Off
Off Off Off
Off Off Off
... ... ...
On On On
1-9