meitav-tec ETN-24-PD-1S Owner's Manual

Meitav-tec Ltd (Contel group)

Tel: +972 (3) 962 6462 Fax: +972 (3) 962 6620

www.meitavtec.com - support@meitavtec.com

ETN-24-PD-1S

Owner's Manual – Installation and Operating Instructions

Please read this manual carefully before installation and use.

Index

Options & Accessories

Installation Instructions

Wiring Connections

DIP switch Configuration

External Sensor Connection

Technician Settings

Operating Manual

1. Options and Accessories

Remote sensor option:

• TS01: Temperature Sensor with 80cm cable.

• RS01: for remote temperature sensing (1 required); for averaging

temperature at 4 locations (4 required) – the thermostat will control on the

average temperature of all 4 locations

• RS02: for averaging temperature at 2 locations (2 required) – the thermostat

will control on the average temperature of both locations

For details on where to purchase accessories, please contact Meitav-tec or

visit our web site at www.meitavtec.com

File: etn-24pd-1s.doc | rev.1.1 | 22/04/2007

Table of Contents

Do you have a question about the ETN-24-PD-1S and is the answer not in the manual?

Page 1: Options And Accessories
• RS02: for averaging temperature at 2 locations (2 required) – the thermostat will control on the average temperature of both locations For details on where to purchase accessories, please contact Meitav-tec or visit our web site at www.meitavtec.com File: etn-24pd-1s.doc | rev.1.1 | 22/04/2007...
Page 2: Installation Instructions
(the designated terminals on the printed circuit board are for internal (factory) use only). “T”-“T0” Terminals can be used in any system configuration when Meitav-tec external sensor is connected and the DIP switch is correctly configured.
Page 3 Internal temp. sensor (Default) external temp. sensor DIP switch S2 (4 switches) is not in use – all switches OFF 5. External sensor connection The sensor must be MEITAV-TEC type. N.TC. Sensor; Temperature ~ Resistance Characteristics Temp °C 10.0 12.8 15.6...
Page 4: Technician Settings
6. Technician Settings 6.1 Proportional output selection 0÷10Vdc or 2÷10Vdc • Press and hold (5 sec.) the MODE button - “0” will appear on display. • Using the “+” button, change the scale to 2÷10Vdc “2” will appear on display. •...