Displaying The Picture; Turning Off The Power - Christie LX400 User Manual

Displaying the picture

1. Make sure that the signal source is sending the signal to
the projector.
2. Press the VOLUME button on the remote control. Use
the ▲/▼ cursor buttons to adjust the volume.
3. Press the INPUT button on the projector.
Each time you press the button, the projector switches
its input port in turn.
4. Press the ASPECT button on the remote control. Each
time you press the button, the projector switches the
mode for aspect ratio in turn.
5. Use the zoom ring to adjust the screen size.
6. Use the focus ring to focus the picture.
7. Use the vertical lens shift dial to shift the picture upward
or downward. It is recommended to adjust the picture
upward.
8. Use the horizontal lens shift dial to shift the picture left or
right.

Turning off the power

1. Press the STANDBY/ON button on the projector or the
remote control.
The message "Power off?" will appear on the screen for
about 5 seconds.
2. Press the STANDBY/ON button on the projector or the
remote control again while the message appears.
The projector lamp will go off, and the POWER indicator
will begin blinking in orange.
Then the POWER indicator will stop blinking and light in
steady orange when the lamp cooling is complete.
3. Make sure that the power indicator lights in steady
orange, and set the power switch to the OFF position
(marked "O").
The POWER indicator will go off. Attach the lens cover.
Do not turn the projector on for 10 minutes or more after turning it off. Turning the projector
on again too soon could shorten the lifetime of some consumable parts of the projector.
WARNING
►Do not touch around the lamp cover and the exhaust vents during use or just
after use, since it is too hot.
LX400 User Manual - Concise
ASPECT
button
STANDBY/ON button
7
020-000166-02 Rev. 1 (08-2009)
INPUT button
Zoom ring Focus ring
Top
UP
Lens shift cover
DOWN
RIGHT
LEFT
POWER indicator
Power
switch