Internet Connectivity Dial-In Clients - THOMSON 716 User Manual

3 Internet Connectivity Dial-In Clients

Introduction
Access methods
Connection protocols
Dial-in clients
E-DOC-CTC-20050803-0002 v2.0
For setting up initial Internet connectivity, using the Home Install Wizard on the
Setup CD or the embedded Easy Setup, refer to the provided Installation and Setup
Guide.
Depending on the configuration of the SpeedTouch™ you may have:
D
irect access:
As soon as the initial configuration has been done, immediate and
uninterrupted WAN access is provided.
In case of direct access, the remote organisation might ask for a user
name and password on an Internet welcome page.
D
ial-in access:
Access must be explicitly established, that is by "dialing" into a Broadband
Remote Access Server (BRAS).
Depending on the SpeedTouch™ configuration, dial-in access is provided via the
SpeedTouch™'s Routed PPPoA or Routed PPPoE packet services with
embedded PPP client.
The applied connection protocol model depends on the service profile you selected
to configure the SpeedTouch™ and should correspond with the Service Provider's
requirements. If your ISP provides PPPoE for instance, you should configure PPPoE.
More information on connection protocols can be found in the Internet Connection
Configuration Guide.
There are different ways of dialing in, depending on the operating system on your
computer and your preferences.
Dial-in method:
Embedded PPP dial-in client:
1 Dial-in client on
embedded pages
2 Windows XP/UPnP
(Internet Gateway
Device)
Host PPP dial-in client for a SpeedTouch™ configured in pure bridging mode:
1 Windows XP
Broadband connection
2 Mac OS X PPPoE dial-in
client
can be used on
following operating
system:
Windows, Mac, unix,
other
Windows XP
Windows XP
Mac OS X
Chapter 3
Internet Connectivity Dial-In Clients
For more
information, see:
"3.1 SpeedTouch™ Web
Pages"
"3.2 Internet Gateway
Device Control Agent"
on page 39
"3.3 Windows XP
BroadBand Connection"
"3.4 Mac OS X PPPoE
Dial-in Client"
35