Ftp File Transfer - THOMSON 716 User Manual

Chapter 1
Your SpeedTouch™

FTP file transfer

Quote site command
16
To allow correct file transfers, set the transfer mode to "binary": At the ftp prompt,
type and press Enter.
bin
Turn on the hashing option to see the progression of the file transfer: At the
ftp prompt type
hash
Example.
/home/doejohn{1}$ftp 192.168.1.254
Connected to 192.168.1.254
220 Inactivity timer = 120 seconds. Use 'site idle <secs>' to change.
Name (192.168.1.254:doejohn):
331 SpeedTouch™ (00-90-D0-01-02-03) User 'doejohn' OK. Password requir
ed.
Password : ######
330 OK
ftp>
ftp>bin
200 TYPE is now 8-bit binary
ftp>
ftp>hash
200Hash mark printing on (8192 bytes/hash mark).
ftp>cd dl
250 Changed to /dl
ftp>put C:\user.ini
200 Connected to 192.168.1.10 port 1271
150 Opening data connection for user.ini
226 File written successfully
ftp: 256 bytes sent in 0,000Seconds 256000,000Kbytes/sec.
ftp>
All the CLI commands can be executed from within an FTP session. Only complete
CLI commands (in other words, the complete command syntax with all the
parameters already specified) can be executed.
Example: To execute the CLI command
currently assigned to SpeedTouch™ interfaces: At the FTP prompt type 'quote site ip
iplist' and press Enter.
quote site ip iplist
ftp>
200- Interface
200- 2 LocalNetwork
200- 2 LocalNetwork
200- 1 Internet
200- 0 loop
200-
200 CLI command "ip iplist" executed
ftp>
For more information on CLI commands, see the SpeedTouch™ CLI Reference Guide.
and press Enter.
:ip iplist
Type IP-address
Ethernet 10.0.0.138
Ethernet *192.168.1.254
Serial 81.240.198.191
Internal 127.0.0.1
to list all IP addresses
Point-to-point/Mask
255.255.255.0
255.255.255.0
81.240.198.1
255.255.255.255
E-DOC-CTC-20050803-0002 v2.0