DigitalBox IMPERIAL HD 2 basic Installation Manual page 34

8. USING THE RECEIVER
GB
Timer Settings
The timer function is used to programme the receiver to begin a specific action, such as
recording, at a defined time. Eight (8) pre-programmed timer settings are available.
Sub-menu
Timer Number
Timer Mode
Timer Service
Start Channel
Start Date
On at
Length
Save your entries by confirming the „Save" screen with OK.
8.8 Settings (symbol: film reel)
Firmware Information
Shows receiver information:
• Bootloader
• Service
• Main code
• Menulogo
• Bootlogo
• Default DB
• UserDB
Installation Guide
Description
Select timer number 1-8..
Specifies the repetition frequency (Once, Daily, Weekly, Off).
The „Off" setting disables the timer.
Channel: At the programmed time, the receiver switches to
the programmed show (even from standby).
Record: If an external USB storage device is properly
connected, you can programme timed recording sessions.
Channel selection
Enter the show start date.
Enter the show start time.
Enter the show length.
Current Version of bootloader
internal service
Current Version of Main code
Current Version of Menu logo
Current Version of Boot logo
Current Version of factory channel list
Current Version of Customer channel list
34