NightWatcher 8 channel D1 Realtime DVR User Manual page 28

Alarm Setup
When the equipment obtains the external alarm signal, the alarm function is turned on.
Set method: refer to Motion detect
Note: "Advanced" button is the same as right click.
Please check current channel status: "○" means it is not in alarming status, "●" means it is in
alarming status.
You can use desktop shortcut menu or click [main
menu] > [alarm function] > [alarm output] to enter
the alarm output interface.
Configuration: Alarm is on according to the
configuration.
Manual: Click the all button and the according
channel is alarming no matter the channel in any
state.
Stop: Click the stop button and the according
channel stops alarming no matter the channel in any
state.
– Alarm Input, Alarm Output, Abnormality
Alarm Input Setup
◆
Alarm Output Setup
◆
Analyzing and inspecting current software and
hardware of the device: When some abnormal
events happen, the device will make a relative
answer such as show message and buzzer.
Event Type: selecting abnormity you want to
inspect
Enable: Select it to make sure abnormal function
workable
Show message: Automatically alarm cue dialog
box come out of the main screen
Buzzer: Device will have two long noise "di di"
while alarm is happen.
Abnormality Setup
◆
27