NightWatcher 8 channel D1 Realtime DVR User Manual page 26

Alarm Setup
– Motion Detection
You can set the area as followed, Drag the mouse and draw
the area. Default: all selected blocks are detection area.
Note: Only the motion detect under hybrid mode have
this function of setting region, and also only the analog
channel can set region.
Period: Trigger the motion detect signal in the set period
section. You can set according to week or set uniformly.
Each day is divided into four time sections. "■" means the
set valid.
Interval: Only one alarm signal is turned on even
there are several motion detect signals in the set
interval.
Alarm output: Start the external equipment of
corresponding linkage alarm when the motion
detect alarm is turned on.
Delay: Delay a few moments and stop when the
alarm state is turned off. The range is 10~300
seconds.
Record channel: Choose the recording channel
(multiple option supportive). Trigger the video
signal when the alarm is turned on.
Note: Set in the [recording setup] and perform the
linkage recording. Start detecting video files in the corresponding time section.
Tour: "■"means that the selective channel is single window alternate patrol preview. The interval is set
in the [Main Menu] >[System] > [Tour].
Snapshot: Choose record channels, when alarm happens, system triggers related channels for
snapshot signal.
Note: For Snapshot activation, please go to set period, detect and alarm enable at Main Menu->
Record->Record configure.
PTZ Activation: Set the PTZ activation when the alarm is turned on.
Note: PTZ activation is set in the [shortcut menu] > [PTZ control]. Set the patrol between spots, trail
patrol and so on.
Delay: When alarm is over, recording will last some seconds (10~300sec), then stop.
Show message: Pop the alarm information dialog box in the local host computer screen.
Send EMAIL: "■"means sending an email to user when the alarm is turned on. (Note: Set in the [Net
Service] and send email.)
25