8S - 8
POWER WINDOW SYSTEMS
REMOVAL AND INSTALLATION (Continued)
possible and push down. Tighten the two loose win-
dow regulator screws to 12 N·m (105 in. lbs.).
(13) Attach the door glass by sliding the two nuts
into the slotted holes on the regulator lift plate.
Tighten the nuts to 12 N·m (105 in. lbs.).
(14) Plug in the wire harness connector to the
power window motor.
(15) Use an adhesive/sealant to install the plastic
watershield to the door inner panel.
(16) Reverse the remaining removal procedures to
complete the installation.
ZG