Jeep 1997 Grand Cherokee Service Manual page 35

TONE WHEEL (ABS)
ZG
REMOVAL AND INSTALLATION (Continued)
(5) Remove the hub mounting bolts and remove
hub bearing from the steering knuckle and axle
shaft.
INSTALLATION
(1) Install the hub bearing and brake dust shield
to the knuckle.
(2) Install the hub to knuckle bolts and tighten to
102 N·m (75 ft. lbs.).
(3) Install the hub washer and nut. Tighten the
hub nut to 237 N·m (175 ft. lbs.). Install the nut
retainer and a new cotter pin.
(4) Install the brake components, refer to Group 5
Brakes.
(5) Install the wheel and tire assembly.
(6) Remove support and lower the vehicle.
WHEEL MOUNTING STUDS
REMOVAL
(1) Raise and support vehicle.
(2) Remove wheel and tire assembly.
(3) Remove brake caliper and rotor, refer to Group
5 Brakes for procedure.
(4) Remove stud from hub with Remover C-4150A
(Fig. 10).
INSTALLATION
(1) Install new stud into hub flange.
(2) Install three washers onto stud, then install
lug nut with the flat side of the nut against the
washers.
BOLT STEERING K NUCKLE
Fig. 9 Hub Bearing & Knuckle
WHEEL STUD
REMOVER HUB AND BEARING BRAKE SHIELD ASSEMBLY
Fig. 10 Wheel Stud Removal
(3) Tighten lug nut until the stud is pulled into
the hub flange. Verify that the stud is properly
seated into the flange.
(4) Remove lug nut and washers.
(5) Install the brake rotor and caliper, refer to
Group 5 Brakes for procedure.
(6) Install wheel and tire assembly, use new lug
nut on stud or studs that were replaced.
(7) Remove support and lower vehicle.
WASHER NUT COTTER PIN RETAINER
SUSPENSION 2 - 9