ZG
REMOVAL AND INSTALLATION (Continued)
POWER MIRROR
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the front door trim panel as described
under Door Module in this group.
(3) Unplug the electrochromic mirror wire harness
connector, if equipped.
(4) Unclip the mirror wire harness(es) from the
inner door panel.
(5) Remove the mirror flag seal (Fig. 4).
(6) Remove the three nuts that secure the mirror
to the door.
(7) Remove the mirror from the door.
(8) Reverse the removal procedures to install.
Tighten the mirror mounting nuts to 7.4 N·m (65 in.
lbs.).
POWER MIRROR SYSTEMS
Fig. 4 Power Mirror Remove/Install
8T - 5