Installing Carburetor Assembly With Linkages; Securing Ground Lead; Fuel Solenoid Lead Secured With Tie Strap; Connecting Fuel Line To Carburetor - Kohler Courage SV470-600 Service Manual

Section 10
Reassembly
6. Attach the choke and throttle linkages to the
carburetor and install the carburetor assembly.
See Figure 10-55. If the governor lever was not
disconnected, slide it onto the governor shaft with
the lever up.
Figure 10-55. Installing Carburetor Assembly with
Linkages.
7. If the carburetor has a fuel solenoid, fasten the
ground lead to the crankcase boss, with the
toothed washer between the eyelet terminal and
the boss. See Figure 10-56. Torque the screw to
8.0 N·m (70 in. lb.). Connect the solenoid power
lead to the wiring harness and secure with a tie
strap. See Figure 10-57.
Figure 10-56. Securing Ground Lead.
10.16
www.SmallEngineDiscount.com
Throttle Linkage
Choke Linkage
Not For Resale
Figure 10-57. Fuel Solenoid Lead Secured with Tie
Strap.
8. Connect the fuel line to the carburetor and secure
with a hose clamp. See Figure 10-58.
Figure 10-58. Connecting Fuel Line to Carburetor.
9. Install the air cleaner base.
a. Install a new air cleaner base gasket. Check
that the two metal spacers are in the air
cleaner base mounting holes and install the
base onto the stud(s), and or alignment pin.
Make sure the upper mounting tab is
positioned above the closure plate boss. See
Figure 10-59. Install the hex. flange nut(s)
and finger tighten See Figure 10-60.