Insert A Micro Sd Card (For Model 2, 3 & 4 Only) - ETS 1 Operation Manual

For Model 2 & 4

ICON
System Status
During powering on
Reset default
Upgrade
Connection Status
LAN connected
LAN disconnected
Internet connected
Internet disconnected
Micro SD Card Status
Micro SD card error
Status during Network Setup
Port forwarding required
* LED blinking frequency -
1.7 Insert a Micro SD Card (For Model 2, 3 & 4 Only)
For local video recording, a micro SD card slot can be found on the side of the camera.
Note: Before inserting a micro SD card, make sure you've copied all important data saved in the card
(if any) to other storage media, or the data will be removed after inserting it to the camera.
Check the indication above to ensure where your micro SD card is, and insert it to your camera.
Note: It's recommended to insert or remove the micro SD card with power disconnected, or the
camera will reboot.
Note: For the compatible list of the micro SD card, please refer to "APPENDIX 5 MICRO SD CARD
COMPATIBLE LIST" at page 34.
LAN connection status
LAN blinking
(on 250 ms, off 250 ms)
Blinking

Blinking

Keep current status for 20 sec  Blinking for 3 sec  Return to current status
 LED on /  LED off
Always on
, Internet off, and then LAN off, Internet blinking

(on 250 ms, off 250 ms)
Always on
(on 100 ms, off 500 ms)
--
--
--
--
3
Internet connection status
Always off
(on 250 ms, off 250 ms)
Blinking
(on 250 ms, off 250 ms)

--
--
Always on
Blinking
(on 100 ms, off 500 ms)

Blinking
(on 5 sec, off 0.5 sec, on 0.5 sec, off 0.5 sec, on 5 sec)
