Rtp - ETS 1 Operation Manual

Port Mapping (Available only in UPnP)
This function can eliminate the need to additionally access the router for port forwarding.
For details, please refer to "Advanced Network Setup" from www.surveillance-download.com/user/m500.swf.
Note: Before using this function, make sure your router supports UPnP, and this function is enabled. If
not, please access your router additionally for port forwarding.
When "Port Mapping" is set to "Enable", the system will automatically assign an IP address or port number for
you if no IP address or port number is entered.
Note: When the configurations are saved successfully, you'll see a message indicating the IP address
and port number assigned to this camera.

3.2.10 RTP

The Real-time Transport Protocol (RTP) is an Internet protocol standard to manage the real-time transmission of
multimedia, such as VLC player.
The media player you want to use for remote access must support RTP transmission for this function to work
normally.
Note: When you're about to end the remote access, please press the stop button on your media player
first, and then close the program. This is to ensure the server receives the stop command, and
also help to protect the server from redundant data transmission.
For Model 3 & 4

Function
 Port Range
The port range used by RTP is limited, and preserving 100 ports between the start port and end port is necessary.
Start Port
End Port
 Video
Address and port for
video transmission
 Audio
Address and port for
audio transmission
Description
The range of the start port is 1024 ~ 65434.
The range of the end port is 1124 ~ 65534.
Set a specific address and port for multicast of profile 1 ~ 4.
The range of the address is limited between 224.0.0.1 ~ 239.255.255.255.
The port for multicast must be an even number.
Set a specific address and port for multicast of audio.
The range of the address is limited between 224.0.0.1 ~ 239.255.255.255.
The port for multicast must be an even number.
13