Network Share (For Model 3 & 4 Only); Network Failure Detection (For Model 3 & 4 Only) - ETS 1 Operation Manual

Step4: Upload the certificate(s) issued by the Certificate Authority, and save.
Step5: Disconnect the camera from your PC or laptop, and connect it to the switch in the LAN environment you
want to use IEEE 802.1x, and the camera will start the authentication later.
3.2.13 Network Share (For Model 3 & 4 only)
This function is used to assign a location in the LAN environment to save the snapshot of events.
Note: This function is available only for Windows operating systems.
The information you set here will be applied when "Network Share" is selected in "Trigger" → "Snapshot" →
"Storage Mode".
To use this function, make sure:
A PC is installed in the same LAN environment as this camera, and you know the IP address of the PC.

A PC account is created as "Administrator" with a user name and password.

A folder in the PC is opened as shared to the user account you assigned.

Note: Please check "APPENDIX 7 PREREQUISITES FOR NETWORK SHARE" at page 37 for more details.
Enable this function, and enter the address of the PC, the folder being shared, and the user name and password
to access the PC. If the information is all correct, you'll see a check in the "Status" column, and you're ready to
go to "Trigger" → "Snapshot" for further configurations.
3.2.14 Network Failure Detection (For Model 3 & 4 only)
Configure this camera to check the network connection of other device periodically, and send notifications via
Email or FTP for disconnection events.
16