External I/O Port; Status Indicator - ETS 1 Operation Manual

External I/O Port

Micro SD
1.5 External I/O Port
This camera supports external I/O device connection, and a I/O terminal block is supplied with this camera for
easy connection.
Below shows which input on the I/O terminal block you should use for wiring when you want to connect an
external device to this camera.
4-pin I/O Terminal Block

1.6 Status Indicator

For Model 1

ICON
System Status
During powering on
Reset default
Upgrade
Connection Status
LAN connected
LAN disconnected
Internet connected
Internet disconnected
Micro SD Card Status
Micro SD card error
Status during Network Setup
Port forwarding required
* LED blinking frequency -
An I/O terminal is supplied with the camera for external alarm device connection.
"D/N IN" is used to connect to an external illuminator.
For connection details, please refer to "1.5 External I/O Port" at page 2.
This port is used to insert a micro SD card to video recording.
Alarm Out Connection Example
LAN connection status
Blinking

Blinking

Blinking

Keep current status for 20 sec  Blinking for 3 sec  Return to current status
 LED on /  LED off
Always on
(on 250 ms, off 250 ms)
(on 250 ms, off 250 ms)
Always on
(on 100 ms, off 500 ms)
--
--
--
--
2
3-pin I/O Terminal Block
Internet connection status
Always off
Always off
Blinking
(on 250 ms, off 250 ms)

--
--
Always on
Blinking
(on 100 ms, off 500 ms)

Blinking
(on 5 sec, off 0.5 sec, on 0.5 sec, off 0.5 sec, on 5 sec)
