7526
Electrophotographic (EP) drive assembly removal
See for the part number.
1.
Remove the paper tray.
2.
Disconnect the transfer module cable (A).
3.
Press the two tabs (B) to release the front access door cover assembly.
4.
Press the two tabs (C) on either side of the transfer module, and lift out the transfer module.
Note: Leave the photoconductor units on the transport belt when removing.
Warning: To avoid damaging the photoconductor drum, hold the photoconductor units by their handle and
place the photoconductor units on a clean surface. Never expose the photoconductor units to light for a
prolonged period of time. See
information.
5.
Remove the cartridges.
6.
Remove the low-voltage power supply (LVPS). See
page
4-104.
4-70
Service Manual
"Handing the photoconductor unit" on page 4-2
B
A
C
"Low-voltage power supply (LVPS) removal" on
for additional