Friendly Robotics Robomow RL1000 Operating & Safety Manual page 62

Message
Displayed
- Mower is searching for the Charging Station but the
Low battery
battery voltage is too low to continue the searching
process
- Robomow is charged through the plug and
Low temp.
ambience temperature is out of range (below 32 ºF
Disc. charger / 0 ºC); disconnect the charger plug from the
Robomow.
- Robomow is charged through the Charging Station
Low temp.
and the ambience temperature is out of range
Waiting...
(below 32ºF / 0ºC);
Left/Mid/Right
- Mowing motor is faulty or disconnected
mow problem
- The Robomow is positioned too close or on top of
Move from Wire
the perimeter wire
Mowing
- The mowing motors have been working under a
Overload
severe load for too long of a time.
Cooling, Wait
- Perimeter Switch is not turned on or not connected
No Wire Signal
to the zone intended to mow
Rain detected
Go to ignore
(Enhanced
- Robomow detects rain upon GO pressing
Manual
Controller only)
Ready
- The battery is fully charged
Keep Charging
Recharge
- The maximum operating time has been reached
Battery
Replace blades
- An automatic reminder to replace the blades is
every 200 hours displayed every 200 hours
Replace lamp
- The Operating Lamp is burnt out
- Calibration failure from interference in the
Retry elsewhere
immediate area
Set Country
- Displayed only on first use.
- Displayed every time the power pack is taken out of
Set Time
the mower (reset operation)
62
Probable Cause/Event
Corrective/User Action
- Drive the mower manually for charging in the
Charging Station
- Robomow charging is not allowed when the
ambience temperature is going down below
32ºF / 0ºC; Disconnect the charger plug and
wait until the temperature will go down or take
the Robomow to be charged in a warmer
place.
- Do not do anything, the charging is stopped
and Robomow is waiting for temperature to
change back to the allowed range; if
temperature stays out of the range for more
than 12 hours, the message is changed to
'Low temp. Press GO'.
- Contact service provider
- Move the Robomow approximately 6 – 10 feet
(1.5 – 3m) away from the perimeter wire and
start again.
- There is no need to do anything – Robomow
will renew automatically the operation, as the
mowing motor will cool down.
- Make sure the Perimeter Switch is connected
to the correct zone and is turned on
- Do not operate Robomow in rainy weather
and wet grass; If you choose to override,
press the GO button; The overriding is valid
for the current operation only
- Keep the charger (power supply) connected
and operating
- Connect the charger to the mower
- Replace the blades and restart the counter of
the blades replacement reminder by choosing
the 'Blades replaced – Clear reminder'
option under the 'User Preferences' menu
- Confirm the message and replace the
Operating Bulb as soon as possible
- Move the Robomow 10-12 feet (3-4m) from
this spot and attempt calibration again.
- Follow prompts on LCD screen to set country
- Set real time clock (day and hour)