Antenna Configuration; Date And Time - Kathrein UFS 902 Operating Manual

Hdtv receiver for satellite reception
Hide thumbs Also See for UFS 902:
Table of Contents

Advertisement

SETTINGS

DATE AND TIME

Local time offset (UTC)
Use the
buttons to set the time zone variation from UTC (formerly GMT) (e.g. for Germany +1 hour).
Use the
buttons to switch to the "Automatic clock change" fi eld.
Automatic time setting
Use the
buttons to select whether the receiver should automatically change over between
summer and winter time. If "On" is selected, the receiver automatically sets itself to the right time.
If you select the setting "Off", you must make the change to and from summer time yourself, using the
"Summertime" fi eld displayed below. Press the
buttons to perform the setting.
update time on
After opening this menu, the currently selected time update setting is displayed (see example above
"Das Erste" or "all channels".
There are two ways (selection using the
buttons) you can update the time using the receiver.
1. You select a specifi c channel for the time update. The time is only updated from this channel
(in the example above "Das Erste" is selected)
2. "all channels" setting. The time information is always drawn from the channel currently selected.
Changing the setting for a specifi c channel:
If you want to change the time update from the channel currently set to another channel, you must
fi rst select the required channel and then open the "Date and Time" menu. In the "update time on" line
select the "actual Channel e. g. (ZDF)" setting.
Press the
button to exit the menu again.
COMMON INTERFACE
See "Common Interface" section

ANTENNA CONFIGURATION

See "First Installation" section, pages 14ff
67

Advertisement

Table of Contents
loading

Table of Contents