Chapter 4 Hardware Settings - TMC TI5VGF User Manual

Chapter 4 Hardware Settings

The following sections describe the necessary procedures and proper
jumper settings to configure the TI5VGF motherboard.
4.1 SW1(1-8): CPU Frequency Selector ......................................... 15
4.2 JP1: DRAM Operating Frequency ............................................ 19
4.3 SW2(1-4): CPU Vcore Voltage Selector
SW3(1-4): CPU Vio Voltage Selector (optional)...................... 19
4.4 JP5: Clear CMOS Selection ...................................................... 15
In the case your motherboard TI5VGF-100MHz has a processor
supporting 100MHz CPU clock (such as AMD K6-2/300) and your
DIMM module is PC100 compliant, the SDRAM clock can be set to
100MHz. Otherwise, set the SDRAM clock at 66MHz.
For the locations of the jumpers, refer to Figure 2 on the following page.
The following examples show the conventions used in this chapter
TI5VGF Pentium MVP3 ATX Motherboard User's Manual
Chapter 4 Hardware Settings
Jumper Open
Jumper Closed
Switch 1 and switch 2 are set to OFF.
Switch 3 and switch 4 are set to ON.
13